Junaidi Saputra from Medan, North Sumatra, try to develop more low flow rider modifications. Indeed, judging from the look of his Yamaha Mio Sporty, a strong impression that only lengthen modifikator axle which is characteristic of low-rider. But, if the scrutiny right, there is an experiment that looked at it skutik garputala logo.
"As shown on the front and rear wheels, a long follow-up," said Junaidi, builder Admair Thula (AT) which is based in Medan. Total length of the motor to be 3.5 meters. That is, dimensions Mio delay of about 1 meter.
Long retreat, retreat, said Junaidi, to 32 cm. This does not include the end of the outer tire. However, there are unique on the retreat, withdraw it. When the construction is typically shaped letters "H", here he made a model "J".
"To be strong due to rim and engine load, the material is taken from galvanized," he explained. This effort shall thumbs up. Imagine, with the rear wheel of a super-wide, the device remains in the middle. If viewed from the tire and rim application, then surely this Mio into Bobber style.
To adjust the back of the already overly stretch, re-house CVT reformed. Way, that part was cut and added to plates 8 cm to match the back, though not quite fit the position because it was too out of place.
Front wheel chopper-like models in the Harley-proved difficult to maneuver. Turning radius is very small like a chopper-style motorcycle HD. Changes made by sliding out and replace komstir triangular shaped enggak again straight, but it resembles a "V".
When asked to roads with berziga-zagging in between rows of cones, the motor was trouble. In fact, the driver must be off the foot many times. However, testing his courage Junaidi to take the road more than 5 km.
"As shown on the front and rear wheels, a long follow-up," said Junaidi, builder Admair Thula (AT) which is based in Medan. Total length of the motor to be 3.5 meters. That is, dimensions Mio delay of about 1 meter.
Long retreat, retreat, said Junaidi, to 32 cm. This does not include the end of the outer tire. However, there are unique on the retreat, withdraw it. When the construction is typically shaped letters "H", here he made a model "J".
"To be strong due to rim and engine load, the material is taken from galvanized," he explained. This effort shall thumbs up. Imagine, with the rear wheel of a super-wide, the device remains in the middle. If viewed from the tire and rim application, then surely this Mio into Bobber style.
To adjust the back of the already overly stretch, re-house CVT reformed. Way, that part was cut and added to plates 8 cm to match the back, though not quite fit the position because it was too out of place.
Front wheel chopper-like models in the Harley-proved difficult to maneuver. Turning radius is very small like a chopper-style motorcycle HD. Changes made by sliding out and replace komstir triangular shaped enggak again straight, but it resembles a "V".
When asked to roads with berziga-zagging in between rows of cones, the motor was trouble. In fact, the driver must be off the foot many times. However, testing his courage Junaidi to take the road more than 5 km.
![[Valid Atom 1.0]](valid-atom.png "Validate my Atom 1.0 feed")
0 comments:
Post a Comment